Not really. Modern bindings are supposed to release the boot under certain conditions. Skiing with bindings that won't come off the boot can be really dangerous and result in torn ligaments and broken bones. I'm not concerned about the material because the bindings are supposed to come off at certain times, and the person I bought the skis from had only used the a few times, mostly cross-country stuff, and I don't think they put a whole ton of strain on the bindings. I also think that the repeated strain of well used skis over the course of a few years is more detrimental to the material than sitting in the garage for 10 years.Whistler wrote:hmmm, okay. You're not worried about the materials on the skis being deteriorated because of their age?Shrinky Dink wrote:You can get the bindings on the skis adjusted to fit the boots you have. I would go to a ski shop and see what they say about adjusting them. I just bought some used skis that are from the 90s but are in really good condition and the bindings were able to be adjusted for some boots I rented for the day.
I didn't have boots, so I rented some from the Outdoor Resource Center at BYU-Idaho. Anyway, when I did this, they did a test to make sure that the bindings were working properly.Any ski shop should be able to test the bindings (although it might cost a small fee) and make sure that they'll release the boot at the appropriate time for your weight, height, and skill level. I currently have my bindings set pretty loose because I'm still a beginner and I fall more frequently than advanced skiers. Just make sure your bindings have 'breaks' on them the breaks come down when the boot is off and makes sure that your ski doesn't go down the mountain without you.